STM8S003F3P6 Minimum Core Dev Board

Description:

This 8-bit development board is for the CPU snobs. Intended to those that wants everything. Speed, super small size AND low cost. This board gives you the power to develop quite complex code at a cost of almost cents. This is one of, if not THE lowest cost Harvard Infrastructure microcontroller on the market. A bullet proof core developed by ST. This little micro will run circles around a Arduino UNO/Nano and costs less than half its price.

Specifications:

• Program memory: 8 Kbyte Flash memory; data retention 20 years at 55 °C after 100 cycles
• RAM: 1 Kbyte•Data memory: 128 bytes true data EEPROM; endurance up to 100 k write/erase cycles
• True 2.95 V to 5.5 V operating voltage
• Flexible clock control - 4 master clock sources   
  • Low-power crystal resonator oscillator   
  • External clock input
  • Internal, user-trimmable 16 MHz RC
  • Internal low-power 128 kHz RC
• Clock security system with clock monitor
• Power management
• Low-power modes (wait, active-halt, halt)
• Switch-off peripheral clocks individually
• Permanently active, low-consumption power-on and power-down reset
• Interrupt management
• Nested interrupt controller with 32 interrupts
• Up to 27 external interrupts on 6 vectors
• Advanced control timer:
  • 16-bit, 4 CAPCOM channels,
  • 3 complementary outputs,
  • dead-time insertion and flexible synchronization
  • 16-bit general purpose timer, with 3 CAPCOM channels (IC, OC or PWM)
  • 8-bit basic timer with 8-bit prescaler
  • Auto wakeup timer
  • Window and independent watchdog timers
• UART with clock output for synchronous operation
• SmartCard
• IrDA
• LIN master mode
• SPI interface up to 8 Mbit/s
• I2C interface up to 400 Kbit/s
• 10-bit ADC, ± 1 LSB ADC with up to 5 multiplexed channels
• Up to 16 I/Os including a couple of high-sink outputs
• Embedded single-wire interface module (SWIM) for fast on-chip programming and non-intrusive debugging

Note: you will need a ST-Link Programmer to program the board.